ABS Plastic Hand Held Enclosures RH Series

Battery Door

Key Features:

  • Electronic hand held enclosures, ideally suited for mounting printed circuit boards.
  • Ergonomically designed for a comfortable fit into the user’s hand.
  • Lap joint construction provides protection against dust accumulation and splashing water.
  • Available in two versions - gasketed (IP65 rated) & no gasket.
  • Gasketed version includes gasket around top & bottom half and around battery door (factory installed).
  • Molded in a general purpose ABS plastic with a light texture (material carries a UL flammability rating of UL94 HB).
  • The top half includes a smooth recessed area for membrane, label or silkscreen.
  • Assembled with M3 Philips self tapping screws.
  • Both top and bottom halves contain P.C. board standoffs molded in (see photos for details).

Photos:

Non-gasketed version
Assembled

Belt Clips:

  • Choice of either black or grey (to match above enclosures)
  • Made from tough nylon material
  • Includes mounting hardware

Black Enclosure Gray Enclosure Gaskets Length Width Depth (Assembled)
RH3011BK RH3015 no 5.12 2.68 0.98
RH3001BK RH3005 yes 5.12 2.68 0.98
RH3051BK RH3055 no 6.30 3.30 1.20
RH3045BK RH3045 yes 6.30 3.30 1.20

Belt Clips

Black Gray
CP-001BK CP-001G

Need Assistance? Contact Us.

Data subject to change without notice.

Tags: battery door, gasket, handheld, PCB, board, belt clip